Dillon Quick-Check Wire Tension Meter (Old) Instrukcja Użytkownika Pobierz pdf (Strona 13)

Quick-Check User Instructions 13

The Quick-Check has an internal temperature sensor inside the electronics cavity.

Dramatic temperature changes (such as moving from a warm vehicle to cooler

outdoors) requires time for the sensor to reach the same temperature. Direct sunlight

will heat the electronics cavity and cause higher readings than actual ambient

temperature. In these cases, use a separate thermometer to determine temperature.

Be certain to enter this temperature into the Quick-Check if using the quick-tensioning

mode with the temperature dependent acceptance window.

For best tension accuracy, use the exact temper

ature of the wire. This may be widely

different from the ambient temperature if the cable has been sitting in direct sunlight.

3.3 Softkey Functions

Now that you’ve seen a simple operation, we’ll explain the softkey functions. Figure 3.3

shows the softkeys available during normal operation.

Figure 3.3 Normal mode softkeys

3.3.1 Top level softkeys

Zero Press this softkey to zero the force display. You would usually press this

at the beginning of a series of tension tests but would not need to do it for

every test unless there is some zero drift.

Clear Pre

ss this softkey and you are prompted to clear the Peak reading or the

Average. Make your choice by pressing the appropriate softkey and that

value is cleared from memory.

Mode Pr

ess the Mode key to scroll through the five display modes. These are

explained below:

Live Tension Mode: The d

isplay shows the live tension.

Dual Peak Mode: T

he display shows the live tension on the top display and

the peak force achieved on the bottom display. To clear the peak, remove

any force on the Quick-Check, press the Clear softkey and follow the

prompts.

Average Capture Mode:

This mode shows the live tension in the top

display and the average of all captured readings on the bottom display. To

capture a reading and add it to the average, press the Avg softkey when

a force is applied to the Quick-Check. Follow the prompts to add (or not)

the reading to the average.

Temperature Mode: T

his mode shows the live tension in the top display

and the current temperature in the bottom display. Also shown is whether

the reading is in Fahrenheit or Centigrade and if the temp is one that was

Entrd (entered) manually.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Dillon Quick-Check Wire Tension Meter (Old) Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Dillon Quick-Check Wire Tension Meter (Old)