Dillon Quick Balance Tension Meter Instrukcja Użytkownika Pobierz pdf (Strona 21)

Quick Balance User Instructions 21

5 Changing Sheaves

As you use the Quick Balance on different diameter cables you must change to the

correct sheave size. To change sheaves, remove the hex head screws pointed out in

Figure 5.1 below. Replace the sheaves with the correct letter sheave and reinsert the

screws and tighten.

Insure sheaves installed agree with sheaves noted in the Wire calibration. Exception:

Sheaves match the wire diameter of the cable to be measured and alternate calibration

is selected as per the instructions in Calibration to Specific Wire Type on page 22.

Insure that the wire rope is riding in the groove of all three sheaves.

Figure 5.1 Changing sheaves

Do not use the Quick Balance with cable larger than indicated on the sheaves.

Overload and damage to the instrument may result.

Do not mix sheave sizes. This will result in inaccurate measurement and possible

overload.

Screws

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Brak uwag

Dillon Quick Balance Tension Meter Instrukcja Użytkownika Strona 21